Digital Temperature Sensor Modules for Linux
DigiTemp is a simple to use program for reading values from 1-wire devices. Its main use is for reading temperature sensors, but it also reads counters, and understands the 1-wire hubs with devices on different branches of the network. DigiTemp now supports the following 1-wire temperature sensors: DS18S20 (and DS1820), DS18B20, DS1822, the DS2438 Smart Battery Monitor, DS2422 and DS2423 Counters,
Embedded Ethernet
About Ethernut Ethernut is an Open Source Hardware and Software Project for building tiny Embedded Ethernet Devices. "When I was your age, we had 8 bit CPUs! And we liked it! And we didn't complain!" Hardware Five Open Source Reference Designs are currently available: Ethernut 1 Minimal low cost version, initially using the ATmega103 CPU, which had been later replaced by the ATmega128. The on-chip
1
リリースã€éšœå®³æƒ…å ±ãªã©ã®ã‚µãƒ¼ãƒ“スã®ãŠçŸ¥ã‚‰ã›
最新ã®äººæ°—エントリーã®é…ä¿¡
処ç†ã‚’実行ä¸ã§ã™
j次ã®ãƒ–ックマーク
kå‰ã®ãƒ–ックマーク
lã‚ã¨ã§èªã‚€
eコメント一覧を開ã
oページを開ã
Registered & Protected by MarkMonitor
http://gnometoaster.rulez.org/
{{#tags}}- {{label}}
{{/tags}}