[RFC Home] [TEXT|PDF|HTML] [Tracker] [IPR] [Info page]
INFORMATIONAL
Network Working Group J. Murai
Request for Comments: 1468 Keio University
M. Crispin
Panda Programming
E. van der Poel
June 1993
Japanese Character Encoding for Internet Messages
Status of this Memo
This memo provides information for the Internet community. It does
not specify an Internet standard. Distribution of this memo is
unlimited.
Introduction
This document describes the encoding used in electronic mail [RFC822]
and network news [RFC1036] messages in several Japanese networks. It
was first specified by and used in JUNET [JUNET]. The encoding is now
also widely used in Japanese IP communities.
The name given to this encoding is "ISO-2022-JP", which is intended
to be used in the "charset" parameter field of MIME headers (see
[MIME1] and [MIME2]).
Description
The text starts in ASCII [ASCII], and switches to Japanese characters
through an escape sequence. For example, the escape sequence ESC $ B
(three bytes, hexadecimal values: 1B 24 42) indicates that the bytes
following this escape sequence are Japanese characters, which are
encoded in two bytes each. To switch back to ASCII, the escape
sequence ESC ( B is used.
The following table gives the escape sequences and the character sets
used in ISO-2022-JP messages. The ISOREG number is the registration
number in ISO's registry [ISOREG].
Esc Seq Character Set ISOREG
ESC ( B ASCII 6
ESC ( J JIS X 0201-1976 ("Roman" set) 14
ESC $ @ JIS X 0208-1978 42
ESC $ B JIS X 0208-1983 87
Note that JIS X 0208 was called JIS C 6226 until the name was changed
Murai, Crispin & van der Poel [Page 1]
RFC 1468 Japanese Character Encoding for Internet Messages June 1993
on March 1st, 1987. Likewise, JIS C 6220 was renamed JIS X 0201.
The "Roman" character set of JIS X 0201 [JISX0201] is identical to
ASCII except for backslash () and tilde (~). The backslash is
replaced by the Yen sign, and the tilde is replaced by overline. This
set is Japan's national variant of ISO 646 [ISO646].
The JIS X 0208 [JISX0208] character sets consist of Kanji, Hiragana,
Katakana and some other symbols and characters. Each character takes
up two bytes.
For further details about the JIS Japanese national character set
standards, refer to [JISX0201] and [JISX0208]. For further
information about the escape sequences, see [ISO2022] and [ISOREG].
If there are JIS X 0208 characters on a line, there must be a switch
to ASCII or to the "Roman" set of JIS X 0201 before the end of the
line (i.e., before the CRLF). This means that the next line starts in
the character set that was switched to before the end of the previous
line.
Also, the text must end in ASCII.
Other restrictions are given in the Formal Syntax below.
Formal Syntax
The notational conventions used here are identical to those used in
RFC 822 [RFC822].
The * (asterisk) convention is as follows:
l*m something
meaning at least l and at most m somethings, with l and m taking
default values of 0 and infinity, respectively.
message = headers 1*( CRLF *single-byte-char *segment
single-byte-seq *single-byte-char )
; see also [MIME1] "body-part"
; note: must end in ASCII
headers = <see [RFC822] "fields" and [MIME1] "body-part">
segment = single-byte-segment / double-byte-segment
single-byte-segment = single-byte-seq 1*single-byte-char
Murai, Crispin & van der Poel [Page 2]
RFC 1468 Japanese Character Encoding for Internet Messages June 1993
double-byte-segment = double-byte-seq 1*( one-of-94 one-of-94 )
single-byte-seq = ESC "(" ( "B" / "J" )
double-byte-seq = ESC "$" ( "@" / "B" )
CRLF = CR LF
; ( Octal, Decimal.)
ESC = <ISO 2022 ESC, escape> ; ( 33, 27.)
SI = <ISO 2022 SI, shift-in> ; ( 17, 15.)
SO = <ISO 2022 SO, shift-out> ; ( 16, 14.)
CR = <ASCII CR, carriage return>; ( 15, 13.)
LF = <ASCII LF, linefeed> ; ( 12, 10.)
one-of-94 = <any one of 94 values> ; (41-176, 33.-126.)
7BIT = <any 7-bit value> ; ( 0-177, 0.-127.)
single-byte-char = <any 7BIT, including bare CR & bare LF, but NOT
including CRLF, and not including ESC, SI, SO>
MIME Considerations
The name given to the JUNET character encoding is "ISO-2022-JP". This
name is intended to be used in MIME messages as follows:
Content-Type: text/plain; charset=iso-2022-jp
The ISO-2022-JP encoding is already in 7-bit form, so it is not
necessary to use a Content-Transfer-Encoding header. It should be
noted that applying the Base64 or Quoted-Printable encoding will
render the message unreadable in current JUNET software.
ISO-2022-JP may also be used in MIME Part 2 headers. The "B"
encoding should be used with ISO-2022-JP text.
Background Information
The JUNET encoding was described in the JUNET User's Guide [JUNET]
(JUNET Riyou No Tebiki Dai Ippan).
The encoding is based on the particular usage of ISO 2022 announced
Murai, Crispin & van der Poel [Page 3]
RFC 1468 Japanese Character Encoding for Internet Messages June 1993
by 4/1 (see [ISO2022] for details). However, the escape sequence
normally used for this announcement is not included in ISO-2022-JP
messages.
The Kana set of JIS X 0201 is not used in ISO-2022-JP messages.
In the past, some systems erroneously used the escape sequence ESC (
H in JUNET messages. This escape sequence is officially registered
for a Swedish character set [ISOREG], and should not be used in ISO-
2022-JP messages.
Some systems do not distinguish between ESC ( B and ESC ( J or
between ESC $ @ and ESC $ B for display. However, when relaying a
message to another system, the escape sequences must not be altered
in any way.
The human user (not implementor) should try to keep lines within 80
display columns, or, preferably, within 75 (or so) columns, to allow
insertion of ">" at the beginning of each line in excerpts. Each JIS
X 0208 character takes up two columns, and the escape sequences do
not take up any columns. The implementor is reminded that JIS X 0208
characters take up two bytes and should not be split in the middle to
break lines for displaying, etc.
The JIS X 0208 standard was revised in 1990, to add two characters at
the end of the table. Although ISO 2022 specifies special additional
escape sequences to indicate the use of revised character sets, it is
suggested here not to make use of this special escape sequence in
ISO-2022-JP text, even if the two characters added to JIS X 0208 in
1990 are used.
For further information about Japanese character encodings such as PC
codes, FTP locations of implementations, etc, see "Electronic
Handling of Japanese Text" [JPN.INF].
References
[ASCII] American National Standards Institute, "Coded character set
-- 7-bit American national standard code for information
interchange", ANSI X3.4-1986.
[ISO646] International Organization for Standardization (ISO),
"Information technology -- ISO 7-bit coded character set for
information interchange", International Standard, Ref. No. ISO/IEC
646:1991.
[ISO2022] International Organization for Standardization (ISO),
"Information processing -- ISO 7-bit and 8-bit coded character sets
Murai, Crispin & van der Poel [Page 4]
RFC 1468 Japanese Character Encoding for Internet Messages June 1993
-- Code extension techniques", International Standard, Ref. No. ISO
2022-1986 (E).
[ISOREG] International Organization for Standardization (ISO),
"International Register of Coded Character Sets To Be Used With
Escape Sequences".
[JISX0201] Japanese Standards Association, "Code for Information
Interchange", JIS X 0201-1976.
[JISX0208] Japanese Standards Association, "Code of the Japanese
graphic character set for information interchange", JIS X 0208-1978,
-1983 and -1990.
[JPN.INF] Ken R. Lunde <[email protected]>, "Electronic Handling of
Japanese Text", March 1992,
msi.umn.edu(128.101.24.1):pub/lunde/japan[123].inf
[JUNET] JUNET Riyou No Tebiki Sakusei Iin Kai (JUNET User's Guide
Drafting Committee), "JUNET Riyou No Tebiki (Dai Ippan)" ("JUNET
User's Guide (First Edition)"), February 1988.
[MIME1] Borenstein N., and N. Freed, "MIME (Multipurpose
Internet Mail Extensions): Mechanisms for Specifying and
Describing the Format of Internet Message Bodies", RFC 1341,
Bellcore, Innosoft, June 1992.
[MIME2] Moore, K., "Representation of Non-ASCII Text in Internet
Message Headers", RFC 1342, University of Tennessee, June 1992.
[RFC822] Crocker, D., "Standard for the Format of ARPA Internet
Text Messages", STD 11, RFC 822, UDEL, August 1982.
[RFC1036] Horton M., and R. Adams, "Standard for Interchange of USENET
Messages", RFC 1036, AT&T Bell Laboratories, Center for Seismic
Studies, December 1987.
Acknowledgements
Many people assisted in drafting this document. The authors wish to
thank in particular Akira Kato, Masahiro Sekiguchi and Ken'ichi
Handa.
Security Considerations
Security issues are not discussed in this memo.
Murai, Crispin & van der Poel [Page 5]
RFC 1468 Japanese Character Encoding for Internet Messages June 1993
Authors' Addresses
Jun Murai
Keio University
5322 Endo, Fujisawa
Kanagawa 252 Japan
Fax: +81 466 49 1101
EMail: [email protected]
Mark Crispin
Panda Programming
6158 Lariat Loop NE
Bainbridge Island, WA 98110-2098
USA
Phone: +1 206 842 2385
EMail: [email protected]
Erik M. van der Poel
A-105 Park Avenue
4-4-10 Ohta, Kisarazu
Chiba 292 Japan
Phone: +81 438 22 5836
Fax: +81 438 22 5837
EMail: [email protected]
Murai, Crispin & van der Poel [Page 6]