Arduino sketch to dump the base64-encoded contents of an SD Card to the serial port.
$ cd <project_dir>
$ ARDUINO_DIR=/usr/share/arduino/ ARDMK_DIR=/usr/share/arduino/ make upload
$ sudo stty -F /dev/ttyACM0 ispeed 115200
$ (stty raw; cat >/tmp/dump_sd.log) </dev/ttyACM0
This Arduino sketch dumps the contents of an attached SD card to the serial port. The sketch queries the card for its capacity, sequentially reads each 512B block, and, for each successfully-read block, encodes the block as two base64-encoded strings and prints them to the serial port.
If a block read reports an error, the sketch prints an error message including the block number.
-
Arduino Core & Arduino Makefile. On Ubuntu,
$ sudo apt-get install arduino-core arduino-mk -
Arduino Uno attached to
/dev/ttyACM0
Wiring for the shield I used:
- +5v
- Ground
- CS → Pin 10
- MOSI → Pin 11
- MISO → Pin 12
- SCK → Pin 13
You may need to adjust the wiring and/or source to match your hardware.
This sketch is built using the Arduino Makefile command line toolchain. To build the sketch, open a terminal and
$ cd <project_dir>
$ ARDUINO_DIR=/usr/share/arduino/ ARDMK_DIR=/usr/share/arduino/ make
If you have an Arduino Uno attached to /dev/ttyACM0, you can uplaod the
sketch with
$ ARDUINO_DIR=/usr/share/arduino/ ARDMK_DIR=/usr/share/arduino/ make upload
For setup and testing, I used minicom
$ minicom -D /dev/ttyACM0
For an actual SD card dump/recovery attempt, I would use the terminal directly
rather than trying to log the data from minicom. You need to set the TTY
parameters to match the Arduino’s serial port configuration
$ sudo stty -F /dev/ttyACM0 ispeed 115200
With that done, you can simply cat the data to a convenient file
$ (stty raw; cat >/tmp/dump_sd.log) </dev/ttyACM0
Use a text editor to get rid of the header & footer information that the sketch includes, then something like the following Python will convert the data (assuming no error blocks) to the binary image from the card:
#!/usr/bin/env python
#
# python dump_to_binary.py <infile> <outfile>
import sys
with open(sys.argv[1], 'rb') as f:
data = f.read()
decoded = ''.join(line.decode('base64') for line in data.split('\n'))
with open(sys.argv[2], 'wb') as f:
f.write(data)
Holler at me if you'd like for me to turn this snippet into a proper script. :)
- How to Use MMC/SDC, with detailed specifics about the SPI interface to SD cards.
- The Arduino SD Library Reference
- Another SD Card File/Image Recovery Tool
- SO posts detailing problems and approaches to SD card SPI init