juice4halt is a Raspberry Pi HAT that acts as a short-duration UPS. It uses 2 supercapacitors to power the Raspberry Pi for a few seconds, enough time for it to safely shut down in the event of a power failure.

To use this device some scripts are needed to enable communication over GPIO, between the Raspberry Pi and the juice4halt. The official site provides some here but this version uses systemd which has some advantages.

Note: This is only tested on the stock Raspberry Pi OS. Other distributions may work but are untested.

The juice4halt module as it looks when installed on a Raspberry Pi Model 3B+. Note the size of those chunky "BIGCAP" capacitors.

1. Triggers automatic safe shutdown on power loss
2. Handles manual reboots transparently
3. Lets you monitor the service status

When the Raspberry Pi boots, systemd activates the juice4halt.service which starts the watchdog.sh script. It sends a GPIO pulse to the juice4halt informing it that booting is complete. Then it loops forever, listening for a pulse from the juice4halt, indicating that power has been lost. At this point, the watchdog exits its loop, and initiates a system shutdown.

When a manual reboot is needed (after installing new software, or for any other reason), systemd runs the safe-shutdown.sh script, as part of the regular shutdown process. This ensures that the juice4halt will be in the correct state on the subsequent boot. If this isn't done, the juice4halt will not operate correctly after the reboot.

When a shutdown is triggered by the watchdog.sh, this automatic shutdown script is bypassed as it isn't required.

Important Note: If the system is commanded to shutdown or poweroff, (as opposed to reboot) power must be physically removed from the juice4halt, and the capacitors must be allowed to fully discharge. The Raspberry Pi will be unable to start a new bootup before the power is completely drained.

1. Ensure that you have completely removed any existing juice4halt configuration on your Raspberry Pi. (Including commands in your /etc/rc.local, etc.)
2. cd to your home directory /home/pi
3. Clone this repo to your Raspberry Pi git clone [email protected]:skhg/juice4halt.git
4. cd to the new juice4halt directory
5. Run sudo ./setup.sh to install systemd configuration.

Run systemctl status juice4halt to see status information and confirm it's running.

Sample output:

● juice4halt.service - juice4halt
   Loaded: loaded (/home/pi/juice4halt/conf/juice4halt.service; enabled; vendor preset: enabled)
   Active: active (running) since Wed 2020-12-30 13:24:17 CET; 3h 25min ago
 Main PID: 353 (watchdog.sh)
    Tasks: 2 (limit: 1939)
   CGroup: /system.slice/juice4halt.service
           ├─ 353 /bin/bash /home/pi/juice4halt/bin/watchdog.sh
           └─6213 sleep 0.2s

Dec 30 13:24:17 television systemd[1]: Started juice4halt.

The watchdog and safe-shutdown script are modified from the orginals provided by juice4halt at https://juice4halt.com/download.