This type of enclosure is built around Heltec CubeCell-GPS LoRaWAN GNSS tracker board.

There are three variants of main Body part:

• with no pin header access (-NPH file name suffix)
• with partial pin header access (-PPH suffix)
• with full pin header access (-FPH)

The enclosure is designed to fit a 44 x 22 x 6 mm 600 mAh Li-Po battery.

3D print two STL files from this folder: Body and Lid. You may pick some printing advisories on my Thingiverse page.
If you are unable to print the parts by yourself - you may consider to find an appropriate local 3D service provider and place an order with assistance of Treatstock or 3DHubs portals.

1. connect battery to the board with JST 1.25mm 2pin female plug ;
2. place HTCC-AB02S board into the enclosure's main body ;
3. connect with SMA pigtail ;
4. put lid on top of the assembly ;
5. fasten the lid with four 2.5x10 mm screws.