Hi!
I used this code to find QMC5883L Compass, but don’t found.
The code compile on ESP32, but don’t show data.
What can I do to test it ?

`#include <Wire.h>

// Set I2C bus to use: Wire, Wire1, etc.
#define WIRE Wire

#define SDA 14 //3 // para teste 14
#define SCL 2 // para teste 2

void setup() {
Wire.begin(SDA, SCL);
//Wire.begin();

Serial.begin(9600);
while (!Serial)
delay(10);
Serial.println("\nI2C Scanner");
}

void loop() {
byte error, address;
int nDevices;

Serial.println("Scanning...");

nDevices = 0;
for(address = 1; address < 127; address++ )
{
// The i2c_scanner uses the return value of
// the Write.endTransmisstion to see if
// a device did acknowledge to the address.
WIRE.beginTransmission(address);
error = WIRE.endTransmission();
Serial.print (" # ");
Serial.print (address);
if (error == 0)
{
Serial.print("\n I2C device found at address 0x");
if (address<16)
Serial.print("0");
Serial.print(address,HEX);
Serial.println(" !");

  nDevices++;
}
else if (error==4) 
{
  Serial.print("Unknown error at address 0x");
  if (address<16) 
    Serial.print("0");
  Serial.println(address,HEX);
}    

}
if (nDevices == 0)
Serial.println("No I2C devices found\n");
else
Serial.println("done\n");

delay(5000); // wait 5 seconds for next scan
}`